Ready or not, another Thursday is here, so let’s make it a good one. That means another week is almost over, and it’s time for Throwback Thursday. This week, I thought we would take a look back to December 2012. That’s when we took a look at what MSD Ignitions has to offer for lighting the fire in your LS swap.
The article, titled Carbureted LS Engines – Ignition and Induction, explains what MSD has to offer for those upgrading their classic hot rod with a carbureted LS engine. Sure, the LS has since been replaced with the LT engine, but good running LS candidates can still be had. The article begins by asking the obvious question, Why would you want to install a carburetor on an LS engine rather than use EFI? That is a question that is frequently asked on many of the message boards and forums that support the GM LS-based engines. Contrary to what some might lead you to believe, let us assure you, there’s no increased risk in killing your motor if you run a carb over a fuel-injected system. The reasons why a carb on an LS makes sense are pretty simple. In LS swaps or street/strip/race cars a carbureted LS is simple and less expensive.
In the original article, we discuss how MSD Ignition has come up with the perfect solution for guys that want to push the LS engine’s power curve to the max with the added benefit of no wiring headaches. We talked to MSD’s Todd Ryden about the cool ignition controller for LS engines, the 6LS. “For guys that want the advantages of GM’s aluminum small block without worrying about miles of wiring with typical EFI systems, our 6LS ignition controller allows them to mount a carburetor on the LS1/LS6 engines or the 6LS-2 on the LS2/LS7 engines. These controllers allow the user to map a timing advance curve, program the two-step rev limiter, or vacuum advance curve for your needs. There’s even a step retard in case you want to run a little nitrous in the mix.”
The 6LS controller is programmable by means of simple plug-in modules, an optional hand-held programmer, a laptop computer; giving the user a variety of ways to adjust RPM and timing. Using a laptop computer for adjustments may be intimidating to some, whereas simply plugging in an MSD module or using the handheld controller may be a bit easier. The versatility of this ignition controller makes it another big plus for car builders wanting to convert their LS EFI to a distributorless carb-based system.
There is a lot more interesting and what might seem surprising information in the original article, and to learn more, you really need to check it out. Carbureted LS Engines – Ignition and Induction. Check back often, as we’ll be sure to bring you more great tech you can use.